This command sets the decay factor for weapon recoil velocity.
weapon_recoil_vel_decay [Decay Factor]
||The decay factor for recoil velocity.
This command sets the amount of time, in seconds, that it takes for recoil to recover in between shots. After this amount of time, recoil will be reset to the same as it is when you shoot your first bullet. If set to 0, you can continuously tap without having any recoil.
This command sets the scale factor for recoil - i.e. the higher this number is, the bigger recoil will be.
We tested this command and found that it may not work at all or as intended. This command sets the "initial recoil suppression factor". This factor sets how much the first shot (or the amount of shots set by weapon_recoil_suppression_factor) of a gun has its recoil supressed for. If you set this to 0, there would be no recoil after the first shot of guns (but shots after that would be normal recoil). With this at 0.5, the first shot of a gun would have 50% of its normal recoil.
We tested this command and found that it may not work at all or as intended. This command sets the number of shots that are fired before a weapon uses normal (unsuppressed) recoil. Suppression is set by weapon_recoil_suppression_factor cvar.
We tested this command and found that it may not work at all or as intended. This command sets the amount of variance between each recoil impulse. In other words, this command can be used to change how random recoil is (with this set to 0 it would be the same pattern every time).